Sandblasting Grit Guide: 120 vs 220 vs 320
Résumé
Pixel’s announcement explains how 120, 220, and 320 grit affect aluminium’s matte finish and reveal die-cast porosity. It also covers how pressure, blast distance, and worn abrasive change consistency, plus finishing options such as paint and anodising.
DEV Community
Sandblasting grit: why 320 shows die-cast porosity
Sandblasting fixes the feel of an aluminium surface with one number: the grit. 120 grit reads matte with visible tooth. 220 grit is fine and even. 320 grit comes close to silk, with very low reflection. Across that range 60-degree gloss lands between 2 and 10 GU and surface roughness between Ra 1.6 and 3.2 micrometres. Grit sets the baseline. Finer is not better. Sand cast and die cast aluminium carry porosity and flow marks, and coarse to medium grit from 120 to 220 covers them; at 320 those defects come back into view. So choosing a grit is really choosing between hiding defects and getting a fine touch, and the two rarely come together. Appearance parts usually want the even matte of 320, and pay for it with fingerprints, which means a clear coat or an anodised seal on top. When two samples from the same batch feel different, the grit is usually not the culprit. Air pressure and blast distance drift between runs. Our working window is 0.4 to 0.6 MPa at a distance of 100 to 150 mm. A pressure gauge reading 0.1 MPa apart changes grit velocity, and pit depth follows. Thirty millimetres of difference in distance is enough for a hand to feel. Media is the item people forget. Recycled abrasive breaks down, the particle size distribution widens, fines increase, and the same grit number polishes smoother - the surface effectively climbs to a finer grit as the day goes on. We had a batch of aluminium parts where the first and last piece felt clearly different; the media had run three days without being changed. The rule is to replace by hours of use or by batch, and to keep a reference sample for comparison. After blasting there are three common routes. Blasting plus paint gives an even matte with free colour choice, moderate weathering, and bare metal showing through once the coating wears. Blasting plus anodising gives a matte metallic look with good wear and weather resistance, because the oxide film is part of the substrate, at the cost of one more process step and a longer lead time. Blasting plus clear coat keeps the metal colour and resists fingerprints. Anodising eats surface detail. Once the oxide film passes 10 micrometres the grain is flattened and the part feels smoother. If visible tooth is the goal, keep the film at 8 to 10 micrometres, or compensate with a coarser grit at the blasting stage. Acceptance cannot rely on feel. Use a gloss meter at 60 degrees plus signed physical standards: a nominal sample, an upper limit and a lower limit. Inspectors compare each batch against all three and pass anything that falls between the limits. Sign a single standard and the batches drift, because nobody knows where the boundary is.

Powered by Readybot.io